• Bulkhead Mounted Blower

Bulkhead Mounted Blower

6622

Provides fresh air to the bilge in order to prevent explosion. Bulkhead Mounted Bilge Blower for 3" intake pipe

Air Flow: 90 CFM
Power Source: DC 12Volts
Current: 3A
Dimensions: (LxWxH) 188x143x160mm (7.41"x5.63"x6.29")

 

  • $89.99

    [$89.99]
- +
 

Flange mount: Blower is mounted on flat bulkhead surface In highest part of compartment free from spray or deck wash. Cut an hole in bulkhead and secure blower with washers and screws dia. 6 ( NOTICE: Tighten screws evenly to avoid flange damage). Use the suitable discharge fitting so that static pressure of blower will not be affected by change in wind direction. Route inlet ductlng with as few bends as possible to lower 1/3 of the bilqe compartment where vapors are likely to accumulate. Be sure ducting is positioned below top of engine strrngers but not so low as to become submerged in bilge water. Locate pickup to take advantage of natural air flow direction.

Write a review

Please login or register to review

Related Products

Rectangular vent with dorade box

Rectangular vent with dorade box

Part Number: 4381

$43.50

Square Vent ABS Plastic - 118mm X 118mm

Square Vent ABS Plastic - 118mm X 118mm

Part Number: 4382

$22.99

Pipe Connector for Square Vent

Pipe Connector for Square Vent

Part Number: 4383

$13.60

Bulkhead Engine Blower - Cont. (12V) - 280 m³/h
Bulkhead Engine Blower - (24V) - 280 m³/h

Bulkhead Engine Blower - (24V) - 280 m³/h

Part Number: 6627

$189.99

Ducting hose for bilge blower 100mm or 75mm

Ducting hose for bilge blower 100mm or 75mm

Part Number: Ducting Hose

from $60.00

Featured Brands