Bulkhead Engine Blower - (24V) - 280 m³/h
Continuous rated centrifugal blower
Provides fresh air to the bilge in order to prevent explosion. Bulkhead Mounted Bilge Blower for 3" intake pipe..
Ideal for galley, toilet and engine room
Constructed withPA6 nylon material certified by RINA prividing a very strong flange mount.
- Approved for continous opoperation
- Ignition protected to ISO 8846
- Stainless metal parts
Specifications:
Air Flow: 280 m³/h (4666 L.Min)
Power Source: DC 24V/2.0A
Dimensions: (LxWxH) 200x165x195mm
Inlet/outlet Pipe: 75mm
$189.99
[$189.99]
Blower is mounted on flat bulkhead surface In highest part of compartment free from spray or deck wash. Cut an hole in bulkhead and secure blower with washers and screws dia. 6 ( NOTICE: Tighten screws evenly to avoid flange damage). Use the suitable discharge fitting so that static pressure of blower will not be affected by change in wind direction. Route inlet ductlng with as few bends as possible to lower 1/3 of the bilqe compartment where vapors are likely to accumulate. Be sure ducting is positioned below top of engine stringers but not so low as to become submerged in bilge water. Locate pickup to take advantage of natural air flow direction.















































